Performing a Pest Inspection Sydney

I'm going to look and see this Pest Inspection Sydney furnace try and get a better age on it just because it looks like they're using inside combustion air we started requiring outside so I'm going to look at that whenever we have looks like an % efficient furnace we do like to see a double wall fluid out a single wall I'm going to know what about that and it does look like they put gas line flex gas line.

Here for the the oven okay we have a drip leg on a gas line we have a water heater so my reports going to put near the end of its useful life typically we get to timber inspection years well that one's years old now so we're coming up coming up to our time we have a combination of copper and abs for our waste lines copper firm our supply lines we've got a flux gas fitting looking at our furnace here usually our date code is bedded into the serial.



This one is prior to so it's not looks like it's about in from the Floor Inspection certification date again a furnace typically last night years so I'm going to have a note that near the end of its useful life and I'm definitely going to recommend a certification we're going to run it make sure everything works correctly look at our numbers things like that but just by each it's coming up to time so you want to make sure the client knows that getting up there in age.

Now in the report I take a picture of your data tag but we're also going to put the serial number and a lot number has a newer igniter dilapidation inspection so they've had some work done on this our gas line is rigid going out flex here that's what we want to see here just on a concrete floor now it's always a good idea when you're looking at a furnace to turn the thermostat on and run it before you inspect it after you inspect it turn the furnace on a thermostat on and run.


It again that way you know that it worked before you inspected the furnace because sometimes they don't you new home inspection also know it works when you left the house that way nobody ends up with a cold house because you didn't get the bottom panel on correctly and the tamper switch is off we have a floor drain here at EPR discharges about six inches from the floor.

so that's all right and we do have our flexible water lines along with our flexible gas lines those are some of the things we're going to look for dryer Home Inspection vents this isn't what we really like to see but it is acceptable as long as it's in exposed area it goes up the backside of the house here so it's a relatively short run we don't ever want to see them over feet and you want to take off for for every so you know I like to kind of look approximate I don't measure them all but

I want to make sure that we're not just really excessive run because they're more prone to the fires.typically I like to run the washing machine just in a in a pre-purchase inspection rinse low just to check the water and water out I tell my clients that the appliances aren't part of a standard I'm not really trying to check the washer and dryer and if there's occupants belongings in their clothes I'm not going to run them but I do like to see something move

Comments

Popular posts from this blog

What To Expect From physiotherapist For The First Time

Is This A Stair Handrail or Sydney guard rails?

Believe In Your Newcastle Removalists Skills